Running a Manual Vulnerability Scan

Procedure

1. Launch Vulnerability Scanner.

   To Launch Vulnerability Scanner On:	Steps
   The Security Server	Navigate to <Server installation folder>\PCCSRV\Admin\Utility\TMVS. Double-click TMVS.exe.
   A client on the network	On the Security Server, navigate to <Server installation folder>\PCCSRV\Admin\Utility. Copy the TMVS folder to the other client. On the other client, open the TMVS folder and then double-click TMVS.exe.

2. Go to the Manual Scan section.
3. Type the IP address range of the clients you want to check.
   1. Type an IPv4 address range.

      Note Vulnerability Scanner can only query an IPv4 address range if it runs on a pure IPv4 or dual-stack client. Vulnerability Scanner only supports a class B IP address range, for example, 168.212.1.1 to 168.212.254.254.

   2. For an IPv6 address range, type the IPv6 prefix and length.

      Note Vulnerability Scanner can only query an IPv6 address range if it runs on a pure IPv6 or dual-stack client.

4. Click Settings.
   The Settings screen appears.
5. Configure vulnerability scan settings. For details, see Vulnerability Scan Settings.
6. Click OK.
   The Settings screen closes.
7. Click Start.
   The vulnerability scan results appear in the Results table under the Manual Scan tab.

   Note MAC address information does not display in the Results table if the computer runs Windows Server 2008.

8. To save the results to a comma-separated value (CSV) file, click Export, locate the folder where you want to save the file, type the file name, and click Save.